TCP/IP Model

The TCP/IP demonstrate was made in the 1970s by the Defense Advanced Research Project Agency (DARPA). As the OSI demonstrate, it depicts general rules for planning and executing PC conventions. It comprises four layers: Network Access, Internet, Transport, and Application:

The accompanying picture demonstrates the examination between the TCP/IP model and OSI display:

As should be obvious from the photo over, the TCP/IP display has fewer layers than the OSI show. The Application, Presentation, and Session layers of the OSI demonstrate are converged into a solitary layer in the TCP/IP shows. Likewise, Physical and Data Link layers are called the Network Access layer in the TCP/IP display.

1. OSI and DoD Models

1.2 DOD Model and it’s capacity

DOD Model maps to OSI demonstrate as beneath:

IP is the convention that works at the Internet layer. It advances the parcels dependent on the system address (IP address) in the bundles and the steering tables.

The four layers of DoD demonstrate from Top to Bottom are:

1. Process Layer: Responsible for the usage of client level applications, for example, mail conveyance, document exchange, and remote login.

Collisions, Collision Domains, and Congestion

                 Another issue with Ethernet is again caused by CSMA/CD: the more devices you put on a segment, the more likely you’ll experience collisions, especially along with devices that constantly need access to the wire. For example, when two devices are on an Ethernet wire, you would not expect to see that many collisions since it would be unlikely that both devices would need to transmit data simultaneously. However, if 100 devices were on the wire, quite a few might need to send traffic simultaneously. When these devices since the wire and simultaneously send their traffic, a collision occurs. And the way CSMA/CD works, they need to create a JAM signal and back off a random time interval before sending again. Of course, the more devices present, the more likely that the “random” time interval they choose is the same as another device, thereby creating even more collisions, greatly slowing down a device’s access when trying to transmit data. On top of this, high-performance
PCs, network-based applications, and high-bandwidth applications such as video can create even more contention for access to the wire.

The Ubnt M2 400 antenna is firstly set to access point.
Then the installation of the station is done. I will tell you how to do this step by step configuration. Let’s first configure the access point side.

Describes how to make screenshots.

Secondly, configure the station side.

I hope it has been a useful article.

Following is a small script on how you can redirect non-payment/ expired PPPoE users to a page where he can be informed that his/her account has been suspended due to non-payment.

Also described are things to do on the radius side

/ip pool add name=expiredpppoe ranges=10.10.10.2-10.10.10.254 /queue type set 0
 bfifo-limit=150000000 kind=bfifo /ip firewall address-list add address=1.1.1.1 
 list=radiusizin

Let’s enter the IP firewall mangle rule in the new terminal as follows.