Category: CCNA

What is RIP (Routing Information Protocol)

Posted on October 3, 2020October 5, 2020 by ali caliskan

Administrative Distance (AD) Before starting RIP we should about Administrative Distance (AD). AD: Sets the priority of routing protocols. If

What is Default Routing?

Posted on August 20, 2020October 3, 2020 by ali caliskan

DEFAULT ROUTİNG Default routing is used to send packets to the next-hop router for an unknown remote destination network that

Ip Routing Protokols -Static Routing

Posted on August 1, 2020August 1, 2020 by ali caliskan

IP ROUTING Routers know how to reach the networks they are connected to. However, they do not know how to

How To Configure The Cisco Router

Posted on July 25, 2020July 26, 2020 by ali caliskan

There are 4 rules to assign IP addresses to the routers. All the interfaces of routers should be in a

How to Create Cisco Router Password for Different Modes?

Posted on July 17, 2020July 22, 2020 by ali caliskan

I want to show you in this article basic routing configuration. But before this ı must explain the mod of

How To Make Static Routing?

Posted on June 23, 2020June 21, 2020 by fadıl

The manual routing of the network administrator is called static routing. When the network structure changes, these routers also need

What is Collision Domain and Broadcast Domain?

Posted on June 16, 2020June 16, 2020 by fadıl

Collision is called the error that occurs at the same time both during packet sending and receiving. This is especially

How to Make Secure Shell (SSH) Settings on the Cisco Router?

Posted on April 24, 2020April 23, 2020 by fadıl

Telnet gibi güvenlik açığı olan bir protokol kullanmak yerine giriş bilgilerinizi ve verileri akışlarınızı şifreleyecek daha güvenli olan bir protokol

How To Install GNS3 On Ubuntu Operating Systems?

Posted on April 2, 2020May 6, 2020 by fadıl

GNS3 is a platform that allows you to create a simulation of a lab environment in a virtual environment without

Ubuntu 18.04 PacketTracer7 Setup How to Fix libpng12.so error?

Posted on March 23, 2020May 6, 2020 by fadıl

Often after installing PacketTracer 7, we get an error like the one below. error while loading shared libraries: libpng12.so.0: cannot