In this post you will Learn about How to Configure two Mikrotik Routerboard SXT and QRT as Point to Point(one as Access Point and other as a station).

Step by step the bridge and the configuration of the station bridge will tell you how to do it.

Step 1

The first step is the wireless configuration of the antenna.

step 2

HT configurations are performed in the second step.

step 3

Multi-Exit Discriminator (MED)

• Non-transitive

• Used to convey the relative preference of entry points

• Influences best path selection

• Comparable if paths are from same AS

• IGP metric can be conveyed as MED

• Multi-Exit Discriminator

• AS 201

• AS 200

• A

• C

• B

• 68.1.0/24

• 68.1.0/24 1000

• 68.1.0/24 2000

Applying Policy with BGP

• Policy based on AS path, community or the network
• Rejecting/accepting selected routes
• Set attributes to influence path selection

Communities

• BGP attribute
• Used to group destinations
• Represented as an integer
• Each destination could be member of multiple communities
• Community attribute carried across AS
• Useful in applying policies
• Community Attribute
• RFC1997, RFC1998
• Optional attribute
• Range: 0 to 4,294,901,760
• Method to group destinations into communities and apply routing decisions (accept, prefer, redistribute, etc.) using route-maps

Community attribute (cont.)

• Format — aa:nn
• aa’ -- ASN
• nn’ — 1 to 4,294,901,760

BGP Communities

• Community 10:200
• Community 10:300
• Community 10:200
• Community 10:300

Load Balancing

• BGP does not load-balance traffic; it chooses & installs a “best” route.

BGP Load Balancing Problem

• “Since BGP picks a ‘best’ route based upon most specific prefix and shortest AS_PATH,
  it becomes non-trivial to figure out how to manually direct specific portions of internal traffic (prefixes) in a distributed fashion across multiple external gateways.”

eBGP Multihop

BGP Multipath

Difficulties in Load Balancing

Internal BGP (iBGP)

• Same routing protocol as BGP, different application
• iBGP should be used when AS_PATH information must remain intact between multiple eBGP peers
• All iBGP peers must be fully meshed, logically; an iBGP peer will not advertise a route learned by one iBGP peer to another iBGP peer (readvertisement restriction to prevent looping)

PPT Slide

• AS 1
• AS 2
• eBGP
• eBGP
• eBGP
• iBGP
• iBGP
• Upstream
• Provider B
• AS200
• Upstream
• Provider A
• AS100

BGP

• What

• Why

• Who

• When

• Where

BGP version 4

• RFC 1771
• Intelligent route selection based  on most specific prefix and shortest Autonomous System (AS) path
• Classless Inter Domain Routing (CIDR) support
• Current Internet standard for inter-domain (AS) exterior routing

Border Gateway Protocol (BGP)

• BGP version 4 is the current  de facto exterior routing protocol in the Internet
• BGP- 4 is required for CIDR

Introduction

• Used for carrying routing information between AS
• Path vector protocol
• Incremental
• Runs over TCP (port 179)
• Conveys information about AS path topology

BGP Between AS’s

“Kid control” is a parental control feature to limit internet connectivity for LAN devices.

Now, wanna show you about the new feature from Mikrotik is kid control. Kid control is a feature for the parent to manage child for the day/time for those to use the internet not let see.

Copy the mac address from the ARP table and paste it to the new kid control device mac address.

MPLS stands for Multiprotocol Label Switching. Multiprotocol because it might be applied with any Layer 3 network protocol, although almost all of the interest is in using MPLS with IP traffic. But that doesn’t actually give us any idea what MPLS does for you (we’ll get to that momentarily).

Depending on which vendor you ask, MPLS is the solution to any problem they might conceivably have. So the question “What is MPLS” could have a lot of right answers. The presentations from this Spring’s MPLS Forum were all over the place on precisely this.