Network

On systems (depending on the project and environment), we often work with local IP's, and we can obtain them from the network settings or through the command line. However, to process real IP's, we can obtain real IP via the router/modem interface or the URL that provides online services (multiple sites are available) and then process. Above is the NCC ripe.net as an example. There is a section above the entrance on the right side that reflects your output rope.

In their spare time, we will continue with the previous post that BuildsTunnel with Mikrotik IPIP at this time we will make a Tunnel with EoIP. Ethernet over IP (EoIP)

Ethernet over Internet Protocol (EoIP), is a protocol in RouterOS that serves to build a  Network Tunnel between MikroTik routers over a TCP / IP connection. EoIP is MikroTik proprietary protocols, to use this feature on the router and the router at the Head Office Branch Office should be the same – the same use MikroTik router. Protocol encapsulation EoIP using Generic Routing Encapsulation (GRE). Data Available at: ( RFC1701 ).

Tutorial Make a WDS Connection in Mikrotik

Basic Theory Wireless Distribution System (WDS)

WDS (Wireless Distribution System) is a system that allows interconnection between the Access Point (AP). This system is used to extend the range of the wireless area, using multiple devices APs into a single entity, without building a network backbone. Terms in building a network of WDS is the AP must use a Band, Frequency, and the same SSID.

Routing Vs Bridging on Wireless Point-to-Point Mikrotik – Wireless Point-to-Point is a wireless communication connection between two points, where one host (access point) is connected to only one client (station). The implementation of Point-to-Point Wireless (P2P) on Mikrotik requires a minimal Level 3 RouterOS license with the bridge-station mode. Wireless P2P Mikrotik can be done by routing or bridging method. Differences in routing and bridging methods on point-to-point wireless Mikrotik are as follows:

WiFi Modem (MiFi) Smartfren Andromax is a multifunction WiFi Modem sold by Smartfren which can be directly used by the user, either using WiFi or USB as 4G LTE modem. But the features in Andromax itself is quite limited, which can only be used for a maximum of 32 users and no user management, and bandwidth management. So if used to be crowded bouts of bandwidth seizure right?

But, why use Smartfren Andromax? why not use other 4G Modem? The answer is simple, because of Smartfren again promo, where buy Andromax Quota, can be quite large, ie 30GB. Steady right?