Fadıl

PATH is the system variable used to locate the files needed to run your operating system from the command line or from the Terminal window.
The PATH system variable is set in operating systems, using the System Utility in the control panel in Windows, and in Linux and Solaris from the shell startup files.
It is not usually necessary to make changes to the system PATH variable on computers running Windows or Mac OS X.

To configure the VLAN in Mikrotik smart switches, all ports that are VLAN must be switched to bridge mode first. If our switch is connected to another device like a router, we will need to use this port as a trunk.

Now it is time to configure our VLAN and for this, we click the switch button from the menu on the left side for my Mikrotik device. In the window that opens, we first create the VLAN that we want to create and we select that port, whichever ether port we want to pass this vena, of course, we add it to the trunk port.

Mikrotik devices now offer us the opportunity to create a welcome message both in the new terminal and when we first entered my device, with the update after the 6.46 version.
Let’s show you how to create it.

To do this, simply click on the note from the system part of the Mikrotik menu. Now we can write the message we want in the window that opens. If we want this message to appear to us at each login, it will be sufficient to select the show at login.

The manual routing of the network administrator is called static routing. When the network structure changes, these routers also need to be changed manually. They are not meant to be replaced by any dynamic routing protocol.

Router>enable
Router#confgigure terminal
Router(config)#ip route 192.168.1.0 255.255.255.0 192.168.0.1

In the example above, the 192.168.1.0/24 network is routed to the 192.168.0.1 gateway.

Predefined Routing

The addresses that the router cannot find as a result of the static and dynamic routing definitions are directed to a predefined address. In case there are roads that can be overlooked as a result of static or dynamic routing, it is recommended to enter the default routing definition to the routers. By default, to route all networks to the 192.168.0.1 gateway;

We will see how to do the Cisco Switch Integration (Syslog). For this, we will do the installation by following the steps below.

The enable command switches from user mod to privileged mod.

Switch>enable

Global configuration mode is passed with the configure terminal command.

Switch# configure terminal

The server IP (for UNIX systems) to be logged after switching to Config mode is specified with the command below.

Switch(config)# logging host  192.168.1.10

After entering the command and pressing Enter, we will see a message as below. It is stated that logging has started on the IP address specified on the 514 port.